Jump to:

• SenseCAP Solar Node P1-Pro
• Heltec MeshTower V2

Repeater Settings

These are specific to the CT Mesh, particularly the 2-byte path hash (important!).

SenseCAP Solar Node P1-Pro

1. Flashing
   1. Go to https://meshcore.io/flasher
   2. Search for “Seeed Studio SenseCAP Solar”
   3. Select “Repeater”
   4. Connect USB-C
   5. Click “Enter DFU mode”, select USB serial device, wait for checkmark on button
   6. Click “Flash!” and wait for completion
2. Settings
   1. Bring up repeater settings page, either:
      1. After flashing, click “Configure via USB”
      2. Go to https://meshcore.io/flasher and click “Repeater Setup”
   2. Click “Connect”, select device
   3. Apply settings from the table, above
   4. Click “Save settings”

Heltec MeshTower V2

[Complete Docs]

As of writing, the latest production MeshCore firmware version v1.16.0 is buggy with the MeshTower. So, we need to use a nightly build until the next release.

1. Flashing
   1. Download the nightly repeater build Heltec_tower_v2_repeater-nightly-*.zip
      1. Latest as of August 2: Heltec_tower_v2_repeater-nightly-20260720-795989b-929d852d.zip
   2. Go to https://meshcore.io/flasher
   3. Search for “Custom Firmware”, select the zip file
   4. Remove the side panel from the device
   5. Turn it ON (switch to the right)
   6. Double-click the RST button (left side) to enter DFU mode - see photo
   7. Connect USB-C
   8. Flick “Flash!” and wait
2. Settings
   1. Go to https://meshcore.io/flasher and click “Repeater Setup”
   2. Click “Connect”, select device
   3. Apply settings from the table, above
   4. Click “Save settings”